Motorhauben Lifter test shuhe

Company is looking currently (urgent!) for owner of #honda #hondacrv 2012-2016 who is ready to get gas bonnet lifts kit in Germany to install it and test for free! First picture shows our kit installed successfuly. Important note: kit is compatible with cars that have threaded hole shown in red circle, pictures of fender without red circle show not compatibility. We need to understand if it depends of engine type, i-vtec or i-dtec.

Schade dafür, das im Internet übersetzt ist.
Company schaut derzeit (dringend!) für den Eigentümer von #honda #hondacrv 2012-2016, wer bereit ist zu veranlassen, dass Gashaubenliftbastelsatz in Deutschland es und Test umsonst installiert! Das erste Bild zeigt unseren Bastelsatz installiert erfolgreich. Wichtige Anmerkung: Bastelsatz ist mit Autos vereinbar, die Loch eingefädelt haben, das im roten Kreis, den Bildern des Kotflügels ohne rote Kreisshow nicht Vereinbarkeit gezeigt ist. Wir müssen verstehen, ob es des Motortyps, i-vtec oder i-dtec abhängt.

Thank you for the answer. Looks like it has these black brackets by default and this bolt, where our bracket can be fitted. But I need to find somebody with i -DTEC, I mean if somebody will send such pictures and I will know for sure that any CR-V with iDTEC engine is not compatible. But I do hope that there are versions with i-Dtec engines that are compatible. If there will be no any compatible car with i-Dtec, we will be ready to give this kit to you. The only thing is that kit itself should be picked up in Vechta 49377, Germany.

Zitat von detroit_steel

Hi AndreyBear,

if you are looking for testers and require them to pick up a kit in Vechta, this will limit the number of potential testers drastically... I mean, who lives in Vechta??

Yes, I know. Maybe, somebody can go there to pick up. In the same time I try to find solution to send this kit. It is important for me to see pictures with diesel engine with needed fixing point, if there will be such, Im sure I will finf solution.

Zitat von Pretender

I have the diesel-engine and i was always looking for an hoodlifter. I will send you the pics tomorrow

Hello. I'm waiting for pictures. By PM?

Zitat von hallo-alle

Hello, I have a 1.6 i-DTEC 160PS 4WD built in 2015. Here are some pictures. These holes are missing. Maybe there is another solution for us, would like to test the system.

Thank you so much! It's a pity. Our kit was very hard to develope, because the design of a body has no places to fix any additional brackets, supporting bonnet's gas springs, so we have found these two points only, so we've developed two huge and strange brackets. And it works since 2014. Now we understand that it will not fit models with diesel. It is common thing in Russia - they dont sell cars with diesel engines almost. So it is hard for us to find the car, to make measuremetnts etc...